Retaining Walls:

Fence & Privacy Walls:

Step One:

• Determine line and height of wall.
• Dig a trench 9 ” deep and 18” wide.
• Fill the trench 6" with level, compacted gravel. (3/4 minus crushed recommended)

• Planning
• Tools
• Materials
• Installation

Step Two:

• Choose a SahaleeStone pattern.
• SahaleeStone Fence patterns are based on 62" lengths. For ease of installation and to avoid block cutting, try to make wall lengths at least 62".
• Begin at the lowest elevation corner.
• Place a string line along length of wall face.

Step Three:

• Install first course of blocks by placing block face flush with string line. Check for level side-to-side and front-to-back.(You may use up to one inch of bedding sand to level blocks.)
• Blocks should be flush against each other. Angle to angle and no gaps between blocks should be showing.

Step Four:

After placing each course of SahaleeStone you will place pins in the proper holes. Click here for pin placement.

The smaller block has only one hole and must recieve a pin each time.

Never build a SahaleeStone fence section utilizing a forward batter within the first course or buried courses.

Step Five:

Continue stacking additional courses of block in a running bond.

Step Six:

Once the final course of your wall has been laid. Cap your wall by placing a bead of concrete adhesive on the last course and setting your cap into place.